SP25A 44

SP25A Series SAE Flange Pump
Features
Patented Non-Symmetrical Gears
PTFE composite bearings
One piece hardened alloy steel gears and driveshaft
Pressures up to 3000 psi
SAE "B" 2 bolt mounting
5 drive shaft configurations available
1.141 to 3.869 ci displacement
Function
The SP25A pump now utilizes self-lubricating thrust blocks that eliminate theneed for separate wear plates. They are made from a high strength aluminumalloy with exceptional anti-galling properties. This new thrust block design also incorporates advanced bearings designed specifically for high pressure hydraulic pumps. This new bearing features a robust fluoropolymer PTFE wear surface that yields unsurpassed load carrying capabilities and cavitation resistance even at low speeds and moderate levels of contamination. Also, since the PTFE resin layer is self-lubricating, contamination from bearing wear in high load situations (when no oil film is present) is reduced. This new thrust block design combined with these advanced bearing results in lower friction and less internal oil loss resulting in higher pump efficiencies.

 

SP25A 44

Categories

Contact Us

  • A&S Hydraulic Co., Ltd
  • 469 Xinsheng Road, Gaoxin District, Chengdu, China
  • Tel: +86-28-65376553
    Cell: +86-18398982650
  • Fax: +86-28-86129221
  • hydraulic@esmachinery.com
  • Contact Person: Sandra Yan
  • Like Us:
Please Complete the short form below and a A&S sales representatives will contact you shortly. Note: Fields labeled with a * are required.
* Product:
* First Name:
* Last Name:
* Company:
  Phone:
   Fax:
*  Email:
*  Inquiry / Comments
*  Code
 
page run: 12 ms